The Bearing cap from China tells you that a typical bearing cap is a typical part of the disc class, and this part is the bearing cap of the reducer. The Bearing cap from China tells you that because of its accessibility, it is also called the bearing cap through the cover. The basic shape of the bearing cap part is a coaxial revolving body.

The Bearing cap from China tells you that the structure of the bearing cap can be divided into two parts, a cylinder and a disc, whose axial dimension is smaller than the radial dimension. There is a tapered inner hole (cavity) in the cylinder, and there is no gap on the edge, indicating that the bearing is grease-lubricated; the outer cylindrical surface of the cylinder is matched with the bearing seat hole.
The Bearing cap from China tells you that there are six cylindrical countersunk holes on the disc structure of the bearing end cap, which are evenly distributed along the circumference. . There is a sealing groove in the round hole in the center of the disc, which is used to install the felt sealing ring to prevent the leakage of lubricating oil in the box and the intrusion of sundries outside the box.
Through the above introduction and analysis of the Bearing cap from China, hope it helps you.